Cyclic and Push-over ductile behavior of steel shear wall strengthened with stiffeners and steel column filled with concrete

Document Type : Original Article

Author

Semnan University

Abstract

Based on the several advantages of steel shear walls as lateral resistant system (stiffness, strength, ductility and energy absorption), the cyclic and nonlinear analysis of steel shear walls strengthened with vertical and horizontal stiffeners and boundary columns filled with concrete was investigated in this paper and displacement controlled analysis at ABAQUS F.E. based on ATC24 protocol for different models were conducted. The numerical model was calibrated with experimental results and then four new steel shear wall models with vertical and horizontal stiffeners and steel column filled with concrete were considered and analysed. The hysteresis curves results conducted in this paper indicated that the steel shear wall with stiffeners and boundary column filled with concrete strength was higher than post-buckling strength, and the steel plate post-buckling strength was fully gained due to increasing rigidity of boundary columns. The absorption energy of strengthened specimen filled with concrete in push-over analysis was 11% higher than non-strengthened specimen without concrete, and also the total energy absorption at cyclic loading of strengthened specimen was 415% (5.15 time) comparing to non- strengthened specimen indicating that this combined stiffeners and concrete filled column was effective. The behaviour ratio of strengthened specimen was 21% more than that of non-strengthened specimen.

Keywords

Main Subjects

References

[1] Iranian seismic design code No 2800, (1394). 4 th version, (In Persian).
[2] Chia- Ming, U. (1991). Establishing R (or RW) and Cd Factor For Building Seismic Provisions. Journal of structural
Engineering, Vol. 117 (Issue 1).
[3] Gholhaki, M., Sabouri-Ghomi, S. (2008). Ductility of thin steel plate shear walls. Asian Journal of Civil Engineering, Vol.9, Page153-166.
[4] Astaneh Asl, A. (2001). Seismic Behavior and Design of Steel walls. AISC. USA.
[5] Sabeli, R., Bruneau, M. (2007). Steel Plate Shear Walls. AISC, Steel design Guide, v20.
[6] Sabouri-Ghomi, S. (1383). Strong systems against lateral loading, new idea for application of soft steel. Nashr Press (In Persian).
[7] Kharrazi, M.H.K. (2005). Rational Method for Analysis and Design OF Steel Plate Shear Walls. Ph.D Dissertation. University of British Columbia, Vancouver, Canada.
[8] Vian, D., Bruneau, M. (2004). Testing Of Special LYS Steel Plate Shear Walls. 13th World Conference on Earthquake Engineering. Vancouver, B.C. Canada.
[9] Gholhaki, M. (1386). Investigation of ductile steel shear wall (with thin plate) behaviour and its beam-column connection effect. Ph.D Dissertation. Khajenasir University, Tehran, Iran (In Persian).
[10] Rahnavard, R., HassaniPour, A., Mounesi, A. (2015). Numerical Study on important parameters of composite steel important parameters of steel concrete shear walls. Journal of constructional steel Research. Vol.121, Page 237-252.
[11] Shishkin, J., Driver, R.G., Gronding, Y. (2009). Analysis of Steel Plate Shear Walls Using the Modified Strip Model. Journal of Structural Engineering. Vol 135 (Issue 11).
[12] Sabouri-Ghomi, S. (1380). Strong systems against lateral loading, Introduction to steel shear walls. Angizeh Press (In Persian).
[13] Sabouri-Ghomi, S., Roberts, T.M. (1992). Nonlinear dynamic analysis of steel plate shear walls including shear and bending deformation. Engineering. Structure, No.5, PP 309-317.
[14] ABAQUS Verification Manual 6.9.1. (2010). USA.
[15] CODE: ATC-24. (1992). Guidelines for Cyclic Seismic Testing of Components of Steel Structures. Applied Technology Council. USA.
[16] Iran National Building Design code. (1992). 9 th Code, Concrete structures. Urban and Road Ministry, Iran.
[17] ACI 318-14 Building Code Requirements for Structural Concrete and Commentary. (2014). American Concrete Institute. USA.
[18] Specification for Structural Steel Buildings AISC LRFD. (2016). American Institute of Steel Construction, USA.
[19] The Uniform Building Code (UBC). (1997). the International Conference of Building Officials, USA.

Files

History

  • Receive Date: 03 August 2017
  • Revise Date: 11 October 2017
  • Accept Date: 24 October 2017

Share

How to cite

Statistics