Seismic Performance Investigation of the Reduced Beam Section Steel Moment-Resisting Frame equipped with Composite Steel Plate Shear Wall with High-Performance Fiber-Reinforced Cementitious Composites

Document Type : Original Article

Authors

1 Assistant Professor, Faculty of Engineering,, Bozorgmehr University of Qaenat, Qaen, Iran

2 Ph.D., Faculty of Engineering, University of Sistan and Baluchestan, Zahedan, Iran

Abstract

In this study, the seismic performance of the reduced beam section (RBS) steel moment-resisting frame (SMRF) equipped with composite steel plate shear wall (CSPSW) and high-performance fiber-reinforced cementitious composites (HPFRCC) is investigated using Abaqus software. The finite element model of HPFRCC-CSPSW was validated using experimental results. Then, the seismic performance of the six-story SMRF with common SPSW, as well as HPFRCC composite CSPSW systems under near-field (NF) and far-field (FF) earthquakes, was investigated and the results (bearing capacity, stress, deformation, and energy absorption) were compared. For this purpose, 5 NF and 5 FF seismic records were used. The results showed that the energy absorption and shear capacity of HPFRCC-CSPSW increased significantly but the maximum stress value decreased compared to common SPSW. The seismic performance of the investigated systems largely depends on the type of earthquake. However, in both SPSW and HPFRCC-CSPSW systems, the maximum displacement and the base shear under the NF earthquakes were higher than those of FF earthquakes. Besides, for all NF and FF earthquakes, maximum displacement in the SPSW system occurred in lower stories, but in the frame with CSPSW, the major displacement occurred in the upper stories. The highest increase in shear capacity and energy absorption of the system in FF earthquakes was for the Tabas accelerometer (75 and 128%, respectively) and the Imperial Vali earthquake (94 and 101%, respectively). Also, the maximum displacement in SPSW and HPFRCC-CSPSW systems occurred in Northridge (14.6 cm) and Tabas (16.2 cm) NF earthquakes, respectively; the Chichi earthquake also had the greatest damage to the structure under FF earthquakes.

Keywords

Main Subjects

References

[1]          Ehsani, R., Sharbatdar, M.K. and Kheyroddin, A. (2020). Experimental Investigation on Flexural Behaviour and Ductility of Two-Span RC Beams Cast with High Performance Composites HPFRCC. Journal of Structural and Construction Engineering, 7(2), 41–62.
[2]          Khorram, N. and Sharbatdar, M.K. (2015). Flexural Strength Study the Deficient RC Slabs Strengthened with HPFRC Different Layers. Concrete Research, 7(2), 81–91.
[3]          Saghafi, M.H., Golafshar, A. and Safakhah, S. (2020).  Evaluation of nonlinear behavior of High Performance Fiber Reinforced Cementitious Composite (HPFRCC) Frames. Journal of Structural and Construction Engineering, 7(3), 214–38.
[4]          Saghafi, M.H., Shariatmadar. H. and Kheyroddin, A. (2017). Experimental evaluation of mechanical properties of high performance fiber reinforced cementitious composites. Concrete Research, 9(2), 29–42.
[5]          Chen, S.J., Yeh, C.H. and Chu, J.M. (1996). Ductile Steel Beam-to-Column Connections for Seismic Resistance. Journal of Structural Engineering, 122 (11), 1292–9.
 [6]         Aibakhshi, M., Ahmadi Jazani, R., Ghobadi, M.S. and Heydari, P.M. (2016). Study on the effect of the first hole distance of beam flange from column face on the seismic behavior of Drilled flange connection (DFC). Analysis of Structure and Earthquake, 12(1), 9–18.
[7]          Gholhaki, M. and Ghadaksaz, M.B. (2017). Investigation of Operation of Link Beam Length in Nonlinear Dynamic Analysis of Steel Plate Shear Walls with Coupling with Rigid Joint. Ferdowsi Civil Engineering, 30(2), 19–32.
[8]          Salimbahrami, R.S. and Gholhaki, M. (2019). Effects of Higher Modes and Degrees of Freedom (DOF) on Strength Reduction Factor in Reinforced Concrete Frames Equipped with Steel Plate Shear Wall. Structures, 19, 234–47.
[9]          Gholhaki, M. and Pachideh, G. (2015). Investigating of Damage Indexes Results Due to Presence of Shear Wall in Building with Various Stories and Spans. International Journal of Review in Life Sciences, 5(1), 992-997.
[10]        Azandariani, M.G., Gholhaki, M., Kafi, M.A., Zirakian, T., et al. (2021). Investigation of performance of steel plate shear walls with partial plate-column connection (SPSW-PC). Steel and Composite Structures, 39(1), 109–23.
[11]        Rouhi, H. and Gholhaki, M. (2022). Assessment of the Seismic Demands of Reinforced Concrete Frames Equipped with Steel Plate shear wall under sequence earthquakes. Amirkabir Journal of Civil Engineering, 54(2), 565-604.
[12]        Liu, J., Xu, L. and Xie, X. (2022). Seismic design and performance of a steel frame-shear plate shear wall with self-centering energy dissipation braces structure. Journal of Building Engineering, 51, 104336.
[13]        Tan, J.K., Zhou, X.H., Nie, X., Wang, Y.H. and Wang, K. (2022). Experimental and numerical investigation of cross-shaped buckling-restrained SPSWs with composite structure. Journal of Building Engineering, 47, 103873.
[14]        Yadegari, A., Pachideh, G., Gholhaki, M. and Shiri, M. (2016). Seismic Performance of C-PSW. In: 2nd international conference on civil engineering, architecture & urban planning elites. London, 2, 110-123.
 [15]       Wu, Y.T., Kang, D.Y. and Yang, Y.B. (2016). Seismic performance of steel and concrete composite shear walls with embedded steel truss for use in high-rise buildings. Engineering Structures, 125, 39–53.
[16]        Shafaei, S., Ayazi, A. and Farahbod, F. (2016). The effect of concrete panel thickness upon composite steel plate shear walls. Journal of Constructional Steel Research, 117, 81–90.
[17]        Sabouri-Ghomi, S., Jahani, Y. and Bhowmick, A.K. (2016). Partial interaction theory to analyze composite (steel-concrete) shear wall systems under pure out-of-plane loadings. Thin-Walled Structures, 104, 211–24.
[18]        Rassouli, B., Shafaei, S., Ayazi, A. and Farahbod, F. (2016). Experimental and numerical study on steel-concrete composite shear wall using light-weight concrete. Journal of Constructional Steel Research, 126, 117–28.
[19]        Kheyroddin, A., Dehghan, M. and Sharbatdar, M.K. (2018). Structural Improvement of Shear Wall Coupled RC Beam Replaced with HPFRCC. Amirkabir Journal of Civil Engineering, 50(3), 471–84.
[20]        Meghdadaian, M. and Ghalehnovi, M. (2019). Improving seismic performance of composite steel plate shear walls containing openings. Journal of Building Engineering, 21, 336–42.
[21]        Yu, J.G., Feng, X.T., Hao, J.P. and Gao X. (2020). Experimental Study of Composite Steel Plate Shear Wall with Flush End-Plate Connection. International Journal of Steel Structures, 20, 136–55.
[22]        Farahbakhshtooli, A. and Bhowmick, A. (2020). Seismic Collapse Assessment of Composite Plate Shear Walls. Journal of Structural Engineering, 146(12), 04020266.
[23]        Ebadi Jamkhaneh, M. andAhmadi, M. (2021). Investigation of connection type effects of composite steel plate shear wall with a circular opening to boundary elements. Journal of Structural and Construction Engineering, 8(7), 165–81.
[24]        Feng, X., Yu, J. and Shen, J. (2021). Seismic behavior of composite steel plate shear walls with rubber-coated uplift-restrained studs. Journal of Constructional Steel Research, 182, 106683.
[25]        Rahimi, T. and Kheyroddin, A. (2021). An Analytical and Numerical Study on Effect of Thickness and Concrete Type of Panels on Behavior of Composite Steel Plate Shear Walls. Amirkabir Journal of Civil Engineering, 53(9), 3623-3648.
[26]        Curkovic, I., Skejic, D., Dzeba, I. and Lukacevic, I. (2021). Behaviour of Composite Plate Shear Walls with Variable Column Stiffness. Ce/Papers, 4(2-4), 754–63.
[27]        Wang, K., Zhang, W., Chen, Y. and Ding, Y. (2022). Seismic analysis and design of composite shear wall with stiffened steel plate and infilled concrete. Materials (Basel), 15(1), 182.
[28]        Zarrin-Tala, H., Maleki, A. and Lotfollahi-Yaghin, M.A. (2022). Evaluation of capacity and performance of composite shear walls with T-shaped stiffeners. Journal of Structural and Construction Engineering, 9(8). https://doi.org/10.22065/JSCE.2022.300411.2537.
[29]        Tsavdaridis, K.D., Faghih, F. and Nikitas, N. (2014). Assessment of perforated steel beam-to-column connections subjected to cyclic loading. Journal of Earthquake Engineering, 18, 1302–1325.
[30]        Saeedi, F., Shabakhty, N. and Mousavi, S.R. (2016). Seismic assessment of steel frames with triangular-plate added damping and stiffness devices. Journal of Constructional Steel Research, 125, 15–25.
Journal of Structural and Construction Engineering
Volume 10, Issue 11 - Serial Number 76
February 2024
Pages 95-117

Files

History

  • Receive Date: 20 December 2022
  • Revise Date: 04 April 2023
  • Accept Date: 04 May 2023

Share

How to cite

Statistics