Investigating the stress-strain behavior of frozen clay using triaxial test

Document Type : Original Article

Authors

1 Assistant Professor, Department of Civil Engineering, North Tehran Branch, Islamic Azad University, Tehran, Iran.

2 Dept. of Civil Engineering, Tabriz, University, Tabriz, Iran

Abstract

Temporary soil improvement methods have always been a concern of geotechnical engineers. Today, the use of methods such as nailing and anchorage is one of the common methods in Iran, while in developed countries, new methods such as artificial ground freezing are also used. The reason for the increasing use of artificial ground freezing, in addition to technical, economic and environmental benefits, is its ability to be used in all boundary conditions and all types of soils. Due to the insignificant laboratory study on the behavior of frozen clay, in this paper, after conducting initial experiments, over 130 unconsolidated-undrained triaxial experiments have been performed on clay samples prepared from the Shurabil Lake site (located in Ardabil). In these triaxial experiments, the effect of freezing, temperature decrease, strain rate increase and confining pressure increase on stress-strain behavior of saturated clay samples has been completely investigated. The results of this study show that decreasing the temperature significantly increases the shear strength and modulus of elasticity of frozen clay samples. Also, due to the presence of ice matrix in the structure of frozen clay, the effect of strain rate is to a large extent, which leads to an increase in shear strength and modulus of elasticity of the samples. Also, all samples showed strain hardening behavior and none of the samples showed brittle rupture. Therefore, the use of artificial ground freezing method in clay soils can be used.

Keywords

Main Subjects


[1]        Sarkhani Benemaran R, Esmaeili-Falak M, Katebi H. Physical and numerical modelling of pile-stabilised saturated layered slopes. Proc Inst Civ Eng Eng 2020:1–16. https://doi.org/https://doi.org/10.1680/jgeen.20.00152.
[2]        Sarkhani Benemaran R. Experimental and analytical study of pile-stabilized layered slopes. Thesis, University of Tabriz, 2017.
[3]        Esmaeili-Falak M. Effect of System’s Geometry on the Stability of Frozen Wall in Excavation of Saturated Granular Soils. Doctoral Dissertation, University of Tabriz, 2017.
[4]        Esmaeili-Falak M, Katebi H, Javadi A. Experimental study of the mechanical behavior of frozen soils-A case study of tabriz subway. Period Polytech Civ Eng 2018;62:117–25. https://doi.org/https://doi.org/10.3311/PPci.10960.
[5]        Esmaeili-Falak M, Katebi H, Javadi A, Rahimi S. Experimental investigation of stress and strain characteristics of frozen sandy soils-A case study of Tabriz subway. Modares Civ Eng J 2017;17:13–23.
[6]        Andersland OB, Ladanyi B. Frozen ground engineering. John Wiley & Sons; 2003.
[7]        Benemaran RS, Esmaeili-Falak M. Optimization of cost and mechanical properties of concrete with admixtures using MARS and PSO. Comput Concr 2020;26:309–16. https://doi.org/http://dx.doi.org/10.12989/cac.2020.26.4.309.
[8]        Esmaeili-Falak M, Katebi H, Vadiati M, Adamowski J. Predicting triaxial compressive strength and Young’s modulus of frozen sand using artificial intelligence methods. J Cold Reg Eng 2019;33:4019007. https://doi.org/https://doi.org/10.1061/(ASCE)CR.1943-5495.0000188.
[9]        Wang J, Nishimura S, Tokoro T. Laboratory study and interpretation of mechanical behavior of frozen clay through state concept. Soils Found 2017;57:194–210.
[10]      Evirgen B. Comparison of individual and sequential copper piping systems in an experimental artificial ground freezing model. Arab J Geosci 2021;14:1–12.
[11]      Zhang Y, Liu S, Lu Y, Li Z. Experimental study of the mechanical behavior of frozen clay–gravel composite. Cold Reg Sci Technol 2021;189:103340.
[12]      Lee MY, FOSSUM AF, Costin LS, BRONOWSKI DR, JUNG J. Frozen soil material testing and constitutive modeling. Sandia National Lab.(SNL-NM), Albuquerque, NM (United States); Sandia …; 2002.
[13]      Li HP, Zhu YL, Pan WD. Uniaxial compressive strength of saturated frozen silt. 8th Int. Conf. Permafr., 2003, p. 679–84.
[14]      Nguyen AD, Sego CD, Arenson UL, Biggar WK. The dependence of strength and modulus of frozen saline sand on temperature, strain rate and salinity. Proc. 63rd Can. Geotech. Conf., 2010, p. 467–75.
[15]      Evirgen B, Onur MI, Tuncan M, Tuncan A. Determination of the freezing effect on unconfined compression strength and permeability of saturated granular soils. GEOMATE J 2015;8:1283–7.
[16]      Esmaeili-Falak M, Katebi H, Javadi AA. Effect of Freezing on Stress–Strain Characteristics of Granular and Cohesive Soils. J Cold Reg Eng 2020;34:5020001. https://doi.org/https://doi.org/10.1061/(ASCE)CR.1943-5495.0000205.
[17]      Tounsi H, Rouabhi A, Jahangir E, Guérin F. Mechanical behavior of frozen metapelite: Laboratory investigation and constitutive modeling. Cold Reg Sci Technol 2020;175:103058.
[18]      Li H, Zhu Y, Zhang J, Lin C. Effects of temperature, strain rate and dry density on compressive strength of saturated frozen clay. Cold Reg Sci Technol 2004;39:39–45.
[19]      Xu X, Wang Y, Bai R, Fan C, Hua S. Comparative studies on mechanical behavior of frozen natural saline silty sand and frozen desalted silty sand. Cold Reg Sci Technol 2016;132:81–8.
[20]      Xu X, Li Q, Xu G. Investigation on the behavior of frozen silty clay subjected to monotonic and cyclic triaxial loading. Acta Geotech 2020;15:1289–302.
[21]      Shastri A, Sánchez M, Gai X, Lee MY, Dewers T. Mechanical behavior of frozen soils: Experimental investigation and numerical modeling. Comput Geotech 2021;138:104361.
[22]      Yugui Y, Feng G, Yuanming L, Hongmei C. Experimental and theoretical investigations on the mechanical behavior of frozen silt. Cold Reg Sci Technol 2016;130:59–65.
[23]      Nassr A, Esmaeili-Falak M, Katebi H, Javadi A. A new approach to modeling the behavior of frozen soils. Eng Geol 2018;246:82–90.
[24]      ASTM D2850-15. Standard test method for unconsolidated-undrained triaxial compression test on cohesive soils. ASTM International; 2016.