%0 Journal Article %T Evaluation of Using Triangular Plates as Continuity Plates in Box Column Section in Prequalified Welded Connections under Cyclic Loading %J Journal of Structural and Construction Engineering %I Iranian Society of Structural Engineering (ISSE) %Z 2476-3977 %A Kafi, Mohammad Ali %A Tarighi, Payam %D 2017 %\ 02/19/2017 %V 3 %N 4 %P 120-138 %! Evaluation of Using Triangular Plates as Continuity Plates in Box Column Section in Prequalified Welded Connections under Cyclic Loading %K Steel structures %K Continuity Plates %K Moment Connections %K reduced beam section %K Triangular Plates %R 10.22065/jsce.2016.41236 %X Welding of Continuity plates in box columns are not easily possible, therefore some researches has been done for substitution of external continuity plates.In this study first discussed about effects of continuity plate in I beam to Box column with top and bottom plate (WFP) and welded unreinforced flange-welded web connection (WUF-W) and reduced beam section connection (RBS). Then, triangular plates use to in connection beam to box column as continuity plates and to consider under cyclic loading. Studies have shown that existence of continuity plates in connections mentioned above have averagely increased loading capacity, rigidity and energy absorption 63, 86 and 75 percent respectively. The results also showed that using of triangular plates as continuity plates of box columns causing plastic strain in column flange in the area that concentration of materials is not much in triangular plates and increased the probability of failure in weld of plates to the column flange. Also using of triangular plates as continuity plates have not affected on plastic hinge location. %U https://www.jsce.ir/article_41236_0a76fbea5f2709df50c0531fbae4d5d4.pdf