@article { author = {Hejazi, Mehrdad and Nazeri, Siyavash}, title = {Out-of-Plane Behaviour of Brick Masonry Infilled Walls with Openings Stiffened with FRP Strips in Reinforced Concrete Frames}, journal = {Journal of Structural and Construction Engineering}, volume = {8}, number = {شماره ویژه 2}, pages = {465-491}, year = {2021}, publisher = {Iranian Society of Structural Engineering (ISSE)}, issn = {2476-3977}, eissn = {2538-2616}, doi = {10.22065/jsce.2020.218844.2072}, abstract = {In this paper, the out-of-plane behaviour of 30 models including two types of brick masonry walls with openings of 6000×3000×300 mm3 and 3000×3000×300 mm3 in two cases of unstiffened and stiffened with FRP strips under cyclic loading has been studied. The width, height and location of the openings have been the variables. A non-linear behaviour has been assumed for the materials and the finite element code ANSYS has been used for analysis. Obtained results indicate that the existence of the opening causes the 3 m wall to crack earlier than the 6 m wall. In 3 m walls, by approaching the opening to the upper corner of the wall the maximum displacement at cracking decreases and this maximum value increases by stiffening the opening. But in 6 m walls with an opening, the effect of the location and dimensions of the opening on this maximum displacement is less. In 3 m walls, by increasing the dimensions of the opening or decreasing its distance from the wall top corner the dissipated energy decreases. This value increases by stiffening the opening. But in 6 m walls, the dissipated energy is less dependent on the opening, although stiffening by FRP strips increases the dissipated energy with respect to unstiffened walls.}, keywords = {Brick Masonry Infilled Wall,opening,FRP Strip,Out-of-Plan Behaviour,cyclic load}, title_fa = {رفتار خارج از صفحه‌ دیوارهای میانقاب آجری دارای بازشو تقویت شده با نوارهای FRP در قاب‌های بتن مسلح تحت بار چرخه‌ای}, abstract_fa = {در این مقاله، رفتار خارج از صفحه دو نمونه دیوار بنایی آجری با بازشو به ابعاد mm3 300×3000×6000 و mm3 300×3000×3000 بدون تقویت و تقویت شده با نوارهای FRP در 30 حالت مختلف تحت بار چرخه‌ای مورد بررسی قرار گرفته ‌است. متغیرها عرض، ارتفاع و موقعیت بازشوها بوده‌اند. رفتار مصالح استفاده شده به صورت غیرخطی در نظر گرفته شده است و از نرم افزار المان محدود ANSYS برای تحلیل‌ها استفاده گردیده است. بر اساس نتایج به دست آمده از تحلیل‌ها، وجود بازشو باعث می‌شود ترک‌خوردگی در دیوار‌ها با طول 3 متر زودتر از دیوارهای با طول 6 متر شروع شود. در نمونه‌های 3 متری هرچه بازشو به گوشه بالایی دیوار نزدیک‌تر باشد حداکثر تغییرمکان در لحظه ترک خوردگی کمتر می‌باشد و با تقویت کنار بازشو‌ها مقدار این حداکثر تغییرمکان افزایش می‌یابد. ولی در نمونه‌های 6 متری بازشودار تاثیر محل و ابعاد بازشو بر این تغییرمکان کم‌تر است. در نمونه‌های 3 متری هرچه بازشو کوچک‌تر و از گوشه بالایی دیوار دورتر باشد مقدار انرژی مستهلک شده بیشتر می‌باشد. همچنین با تقویت کنار بازشو‌ها انرژی مستهلک شده افزایش می‌یابد. ولی در نمونه‌های 6 متری تاثیر بازشو بر مقدار انرژی مستهلک شده کمتر است، هر چند با تقویت توسط نوارهای FRP انرژی مستهلک شده نسبت به حالت تقویت نشده افزایش می‌یابد.}, keywords_fa = {دیوار میانقاب آجری,بازشو,نوار FRP,رفتار خارج از صفحه,بار چرخه‌ای}, url = {https://www.jsce.ir/article_109375.html}, eprint = {https://www.jsce.ir/article_109375_d2e6389553d3bec239528e65958b80ee.pdf} }