برای انجام تحلیلهای دقیق از نحوهی عملکرد سازهها در زلزله، استفاده از رکوردهای مناسب اجتناب ناپذیر است. از آنجا که در اکثر نقاط کشورمان ایران، رکورد زلزلههای بزرگ موجود نیست، استفاده از روشهای شبیه سازی زلزله مفید خواهد بود. در تحقیق حاضر برای به دست آوردن پارامترهای چشمه لرزهزای زلزله رودبار و منجیل (۱۳۶۹) با در نظر گرفتن مدل گسل محدود، یک توزیع فرضی برای لغزش و زاویهی آن در نظر گرفته شده، سپس با استفاده از روش عدد موج-گسسته که روشی تعیّنی برای محاسبه تابع گرین است، رکورد زلزله در ایستگاههای مختلف تولید شده و با فیلتر کردن، از قسمت فرکانس پایین آن استفاده میشود. برای به دست آوردن قسمت فرکانس بالای زلزله از روش شبیهسازی کاتورهای استفاده شده است. با جمع کردن این دو قسمت در فضای زمان، رکورد نهایی به دست میآید که با مقایسهی آن با رکورد واقعی ثبت شده در همان ایستگاهها، میتوان فرضهای اولیه را اصلاح کرده و با چند بار سعی و خطا پارامترهای چشمه لرزهزا را به دست آورد. برای بررسی صحت نتایج از مقایسه مقادیر شتاب و سرعت با مقادیر شدت مرکالی گزارش شده در نقاط مختلف منطقه استفاده شده است. تطابق خوبی بین تاریخچه زمانیهای شبیهسازی و مشاهده شده و مقادیر شدت بدست آمده و گزارش شده، حاصل شده است. جزئیات نتایج به دست آمده در متن مقاله آورده شده است. بهترین سناریوی به دست آمده در این تحقیق سرعت گسیختگی ۲۵۰۰ متر بر ثانیه، تابع زمان خیزش رمپ با زمان خیزش ۳ ثانیه و مرکز زلزله ° 36.82 شمالی و ° 49.40 شرقی میباشد
For time history analysis of structures, appropriate records are needed. Due to the lack of strong-motion records from large earthquakes in some parts of Iran (e.g. Tehran region), earthquake simulation is a useful tool for studying strong-motion characteristics. In this study, a hybrid method has been used for obtaining source parameters of the 1990 Rudbar-Manjil earthquake (Mw7.3). In this simulation we assume fault plane, slip distribution and etc., then each parameter optimized after comparing simulated results with observed ones. In this hybrid method low frequency component of record obtained by the wave-number scheme that is a deterministic method and high frequency component obtained by the stochastic simulation method of Boore (2003), extended to the case of finite faults. Records from the stochastic method filtered with a high pass filter (fc=1.5 Hz) and results from the deterministic method filtered with low pass filter (fc=1.5 Hz), then the time-histories have been combined/added in the time domain. Final results have been compared with observed PSA and PSV in specified strong-motion stations. After comparing, optimized parameters have found, then based on this optimized parameters intensity contour has drawn; simulated intensity contours show good match with and observed ones. Best parameters are 2500 m/s for rupture velocity and 3 seconds for ramp function (i.e. rise time) and 36.82° N and 49.40° for earthquake epicenter. The results are important for the assessment of hazards in other seismically active parts of Alborz mountains (e.g. Greater Tehran area).